22.214.171.124. Stabilizer and leversInstallation of brackets of the stabilizer
||1 – pillow;
2 – bracket;
3 – bar
At removal of the stabilizer of cross stability and levers it is necessary to pay attention to adjusting washers 2 (see rice. Adjustment of a longitudinal inclination of an axis of turn of a wheel) which have to be established at assembly of a suspension bracket on former places of a bar of the stabilizer for preservation of factory adjustment.
It is also necessary to check planeness of a bar of the stabilizer. If one of the ends is raised rather general plane more than on 20 mm, then to correct it or to replace a bar new.
If rubber pillows 1 (see rice. Installation of brackets of the stabilizer) it is free, without resistance move on a bar 3, they are required to be replaced.
Before installation of rubber pillows on a bar of the stabilizer of a pillow and a surface of a bar it is necessary to moisten with soap water.
1 and brackets 2 stabilizers on a bar 3 and their arrangement to make installation of rubber pillows in adaptation providing the size A between brackets.
Cutting of rubber pillows for their facilitated installation on a stabilizer bar is not allowed.