|
6-1-6-1-teleskopicheskaya-stojjka.html
6.1.6.1. Telescopic rackFastening of a support of a telescopic rack
|
|
1 – the self-stopped nuts;
2 – limiter;
3 – support case;
And – tags |
Removal
| PERFORMANCE ORDER |
| 1. To install the car on the horizontal platform of the elevator or a viewing hole and to slow down back wheels the lever of the parking brake. |
| 2. To take off decorative caps and to weaken bolts of fastening of disks of forward wheels, without turning out them. |
| 3. To lift a forward part of a body, to remove wheels and to lower a body on supports. |
| 4. To put tags And (see rice. Fastening of a support of a telescopic rack) a relative positioning of the case 3 support are resistant concerning a body mudguard. |
| 5. To turn off a koronchaty nut of fastening of the spherical hinge of steering draft and to vypressovat his finger from a conical opening of the rotary lever by means of a stripper. |
| 6. To turn off two self-stopped nuts of bolts 30 (see rice. The forward suspension bracket of the car) fastenings of flanges of a telescopic rack to a lug of a rotary fist and freely to remove the top bolt. |
| 7. The lower bolt is taken from an opening only by method of its reversing from a carving opening of the adjusting ram 51 which remains in a fist opening. For an exception of casual drop-out of the ram of a nest it is necessary to fix the ram by a soft wire. |
| 8. To disconnect flexible brake hoses from an arm of a telescopic rack. |
| 9. After removal of three nuts 1 (see rice. Fastening of a support of a telescopic rack) fastenings of a support to a cup of a mudguard to lower a telescopic rack down. |
|
Adjustment
For avoidance of violation of angles of installation of the operated wheels it is recommended to carry out after dismantling works of a rack adjustment at the special stand.
In case of lack of the special stand as an exception, the following technique of removal of a damping rack without violation of an initial corner of disorder of forward wheels is allowed.
| PERFORMANCE ORDER |
| 1. Before an otvorachivaniye of the lower bolt 30 (see rice. A forward suspension bracket of the car) it is necessary to mark with a kerneniye a relative positioning of one of bolt head sides concerning a rack tank bracket. |
| 2. Further it is necessary to weaken a nut of the lower adjusting bolt, and then to wrap the lower bolt against the stop, considering at the same time quantity of turns. |
| 3. After separation of a rack with a fist to fix the ram. |
| 4. At installation of a rack to twirl an adjusting bolt against the stop, and then to turn off a bolt on the same quantity of turns before combination of adjusting tags, its tax against the stop and, holding a bolt head from a provorachivaniye, to tighten a nut. |
|
|
|
