|
4-9-3-3-kolenchatyjj-val-i-makhovik.html
4.9.3.3. Bent shaft and flywheelSets of inserts of bearings of the repair sizes and the repair sizes of necks of a bent shaft at engines of fashion. 331, 3317 and 3313
|
Name of a set
|
Designation
|
Thickness of an insert, mm
|
The repair size of a neck of a shaft after grinding and polishing, mm
|
|
Set of inserts and bearings on one engine:
|
|
nominal size
|
412 – 1000102 – 03
|
1,823 – 1,830
|
59,947 – 59,960
|
|
reduced by 0,25 mm
|
412 – 1000102 – 13
|
1,948 – 1,955
|
59,697 – 59,710
|
|
the same 0,5 mm
|
412 – 1000102 – 23
|
2,073 – 2,080
|
59,447 – 59,460
|
|
the same 0,75 mm
|
412 – 1000102 – 33
|
2,198 – 2,205
|
59,197 – 59,210
|
|
the same 1,0 mm
|
412 – 1000102 – 43
|
2,323 – 2,330
|
58,947 – 58,960
|
| Set of inserts of conrod bearings on one engine |
|
nominal size
|
412 – 1000102 – 03
|
1,823 – 1,830
|
51,994 – 52,012
|
|
reduced by 0,25 mm
|
412 – 1000104 – 13
|
1,948 – 1,955
|
51,744 – 51,762
|
|
the same 0,5 mm
|
412 – 1000104 – 23
|
2,073 – 2,080
|
51,494 – 51,512
|
|
the same 0,75 mm
|
412 – 1000104 – 33
|
2,198 – 2,205
|
51,244 – 51,262
|
|
the same 1,0 mm
|
412 – 1000104 – 43
|
2,823 – 2,330
|
50,994 – 51,012
|
On radical and conrod necks, and also cheeks of a bent shaft of a crack are not allowed. If they are found, it is necessary to replace a shaft.
Insignificant teases on necks can be smoothed out by whetstone of a carborundum of small granularity. If risks very deep or necks have ovality more than 0,03 mm, grind them.
Radical and conrod necks need to be ground, reducing their sizes by 0,25 mm to receive, depending on wear degree, the certain repair size specified in the tab. Sets of inserts of bearings of the repair sizes and the repair sizes of necks of a bent shaft at engines of fashion. 331, 3317 and 3313.
After grinding and the subsequent operational development of necks it is necessary to wash out well a bent shaft for removal of the remains of an abrasive. Several times to wash out channels for lubricant with remote caps gasoline under pressure. On the first cheek of a bent shaft it is necessary to specify the size of reduction of necks (0,25; 0,50 mm, etc.).
Ovality and conicity of radical and conrod necks after grinding have to be no more than 0,007 mm.
|
|
