|
|
|
|
4-5-ustanovka-privoda-raspredelitelya-zazhiganiya-na-dvigatelyakh-mod-331-i-3317.html
4.5. Installation of the drive of the distributor of ignition on engines of fashion. 331 and 3317
| PERFORMANCE ORDER |
|
1. To turn a bent shaft clockwise to situation at which the piston of the first cylinder is in the provision of a step of compression (both valves are closed, and the first tag 3 on a pulley of a bent shaft in the direction of its rotation is combined with an edge of an adjusting pin 1 on the lower cover of distributive asterisks), at the same time the piston will not reach VMT on 10 ° (the ignition moment). |
| 2. To turn the ignition distributor drive roller so that the groove with which the distributor coupling is hooked was displaced towards a bent shaft and is located at a small angle (3–5 °) to an axis of a bent shaft (clockwise). |
|
3. To install carefully the ignition distributor drive in a nest of the lower cover of distributive asterisks, without turning it around an axis. When the gear wheel of the drive of the distributor enters gearing with the leading gear wheel fixed on the forward end of a bent shaft, a groove on the roller, having a little turned at the same time counterclockwise, will reach the correct position – parallel to an axis of a bent shaft A – And. |
| 4. To tighten nuts of fastening of the drive of the distributor. |
|
|
|
|
