Replacement of cuffs. AZLK 2141 (Muscovite)
Service and car repairs of 2141 - the Muscovite.
1. General data
2. Engines
3. Power supply system
4. Cooling system
5. Transmission
6. Running gear
7. Tires, wheels
8. Steering
9. Brake management
9.1. Specifications and characteristics
9.2. General assessment of technological level of a condition of brake management
9.3. Main cylinder of a brake
9.4. Removal and dismantling of the main cylinder of a brake
9.5. Assembly of the main cylinder of a brake
9.5.1. Replacement of cuffs
9.6. Vacuum amplifier
9.7. Brake mechanisms of forward wheels
9.8. Brake mechanisms of back wheels
9.9. Adjustment of the mechanism of the manual drive of the parking brake system
9.10. Pressure regulator
9.11. Signaling device
9.12. Removal of air from a hydraulic actuator of brakes (pumping of brakes)
9.13. Reduction of the signaling device in the working condition
9.14. Possible malfunctions of brake management
10. Body
11. Electric equipment
12. Electrical circuitries
 

fd148775









9-5-1-zamena-manzhet.html

9.5.1. Replacement of cuffs

Before assembly it is attentive to examine and be convinced of absolute purity of "mirror" of the main cylinder and the working surface of pistons, of lack of a rust, рисок and other roughnesses.

For elimination of defects on "mirror" of the main cylinder its honingovaniye is allowed, however at the same time diameter of "mirror" of the main cylinder should not exceed a certain size.

At the defects causing significant increase in diameter of "mirror" of the main cylinder, its case should be replaced new.

At each dismantling of the main cylinder it is necessary to replace cuffs even if by the form they in good shape.

To check elasticity of springs of pistons. To wash out all details pure brake fluid.


Prevention

Hit of mineral oils, gasoline, kerosene or diesel fuel on a detail since even traces of these liquids can lead to destruction of rubber cuffs is not allowed.


Limits of the admissible sizes and wear in the main interfaced details of brake management

Name of details
Maximum permissible size, mm
Maximum permissible wear, mm
on thickness
on diameter
Piston of the main cylinder of a brake
20,815 (diameter)
0,12
Working surface
(mirror) of the main cylinder of a brake
21,081
0,06


9.5. Assembly of the main cylinder of a brake

9.6. Vacuum amplifier