11-6-2-5-sborka-i-ustanovka-startera.html

11.6.2.5. Assembly and installation of a starter

To make assembly of a starter as it should be, the return to dismantling taking into account that the starter anchor shaft neck carving on which the drive moves before assembly should be washed out gasoline or kerosene, to wipe and oil engine.

At inclusion of a starter the drive has to move on an anchor shaft carving without jammings and come back to a starting position under the influence of a returnable spring. The gear wheel of the drive has to be turned freely by hand clockwise on an anchor shaft, and at the return rotation has to rotate together with an anchor shaft.

After assembly of a starter to check and adjust an axial gap of an anchor. The axial gap of an anchor is established by means of the adjusting washers located on a shaft neck from a collector and there have to be no more than 0,7 mm.