Check and adjustment of the drive of a starter. AZLK 2141 (Muscovite)
Service and car repairs of 2141 - the Muscovite.
1. General data
2. Engines
3. Power supply system
4. Cooling system
5. Transmission
6. Running gear
7. Tires, wheels
8. Steering
9. Brake management
10. Body
11. Electric equipment
11.1. Wires and safety locks
11.2. Block of safety locks and relay
11.3. Scheme of internal connections of the block of safety locks and relay
11.4. Rechargeable battery
11.5. Electric equipment installed on cars of fashion. 2141-01, 2335
11.6. Electric equipment (21412-01, 214122, 214123 and 23352, 233522, 233523)
11.6.1. Generator 581.3701
11.6.2. Starter 4216.3708
11.6.2.1. Technical characteristic of a starter
11.6.2.2. Check and adjustment of the drive of a starter
11.6.2.3. Dismantling of a starter
11.6.2.4. Check and repair of a starter
11.6.2.5. Assembly and installation of a starter
11.6.3. System of ignition of the engine of fashion. 331i 3317
11.6.4. System of ignition of the engine of fashion. 3313
11.7. Electric equipment (2141-01, 21412-01, 214122, 214123 e 2335, 23352, 233522, 233523)
11.8. Control devices
12. Electrical circuitries
 










fd148775

11-6-2-2-proverka-i-regulirovka-privoda-startera.html

11.6.2.2. Check and adjustment of the drive of a starter

At turning on of the traction relay 18 (see rice. Starter 4216.3708.) a starter the gap between a gear wheel of the 25th drive and a persistent washer 24 (at completely involved anchor) has to be 4±1,0 mm. This gap is provided konstruktsionno.

At discrepancy of a gap to the specified size it is necessary to check connection of the lever 21 with the drive.

With wear of the lever it needs to be replaced.

Check

PERFORMANCE ORDER
Check of a starter on lack of short circuit of windings on "weight"
1. To disconnect an excitement winding conclusion from the relay.
2. To remove the starter case.
3. To remove to a traverse.
4. To bring to a conclusion of a winding of excitement and to the starter case tension (through a control lamp) from the rechargeable battery or network. If the lamp lights up, then it will indicate short circuit of a winding of excitement on "weight".
Check of short circuit of a winding of an anchor on "weight"
5. To raise the uninsulated and isolated brushes.
6. To bring tension to lamels of a collector and the case of a starter.
7. If the lamp lights up, it will indicate short circuit in an anchor winding.
Check of lack of short circuit of the isolated brush holders on "weight" (traverse)
8. (Traverse) to carry out an inspection of lack of short circuit of the isolated brush holders on "weight" as well as at the previous check.
However to bring tension to the isolated brush holder and to "weight" (traverse).


11.6.2.1. Technical characteristic of a starter

11.6.2.3. Dismantling of a starter