Replacement of the bearing of a rotor from the drive. AZLK 2141 (Muscovite)

Service and car repairs of 2141 - the Muscovite.
	1. General data
	2. Engines
	3. Power supply system
	4. Cooling system
	5. Transmission
	6. Running gear
	7. Tires, wheels
	8. Steering
	9. Brake management
	10. Body
	11. Electric equipment
		11.1. Wires and safety locks
		11.2. Block of safety locks and relay
		11.3. Scheme of internal connections of the block of safety locks and relay
		11.4. Rechargeable battery
		11.5. Electric equipment installed on cars of fashion. 2141-01, 2335
			11.5.1. G-222 generator
				11.5.1.1. Technical characteristic of the generator
				11.5.1.2. Control checks of the G-222 (581.3701) generator
					11.5.1.2.1. Check of a winding of excitement of a rotor
					11.5.1.2.2. Check of the stator
					11.5.1.2.3. Check of gates vypryamitelny block
					11.5.1.2.4. Check of the regulator of tension
					11.5.1.2.5. Possible malfunctions of the G-222 generator
					11.5.1.2.6. Dismantling and assembly of the generator
					11.5.1.2.7. Replacement of the brush holder
					11.5.1.2.8. Replacement of the bearing of a rotor from the drive
			11.5.2. Starter 35.3708
			11.5.3. System of ignition of the engine of fashion. 2106
		11.6. Electric equipment (21412-01, 214122, 214123 and 23352, 233522, 233523)
		11.7. Electric equipment (2141-01, 21412-01, 214122, 214123 e 2335, 23352, 233522, 233523)
		11.8. Control devices
	12. Electrical circuitries

11-5-1-2-8-zamena-podshipnika-rotora-so-storony-privoda.html

11.5.1.2.8. Replacement of the bearing of a rotor from the drive

PERFORMANCE ORDER

1. To take the faulty bearing 19 of a cover 15, (see rice. Generator G details - 222), it is necessary to turn off the nuts of screws which are pulling together washers of the 14 and 17 fastening of the bearing and then to remove washers with screws and on a manual press to vypressovat the bearing.

2. If nuts do not turn away (the ends of screws of a raskernena), then to cut the ends of screws.

3. It is possible to install the new bearing in a generator cover only if the opening for the bearing is not deformed. Diameter of an opening has to be 41,967–41,992 mm.

4. If the opening has bigger diameter or is deformed, to replace a cover new.

5. To press the bearing in a cover on the press and then to clamp between two washers which are pulled together with screws with nuts. After tightening of nuts to raskernit the ends of screws.

11.5.1.2.7. Replacement of the brush holder

11.5.2. Starter 35.3708