Caps of wheels. AZLK 2141 (Muscovite)
Service and car repairs of 2141 - the Muscovite.
1. General data
2. Engines
3. Power supply system
4. Cooling system
5. Transmission
6. Running gear
7. Tires, wheels
7.1. General information about tires
7.2. Marking of tires
7.3. Wear of tires
7.4. Care of tires
7.5. Possible malfunctions of tires, reasons of their emergence and ways of elimination
7.6. General information about wheels
7.7. Balancing of wheels
7.8. Caps of wheels
7.9. Fastening of a spare wheel
8. Steering
9. Brake management
10. Body
11. Electric equipment
12. Electrical circuitries
 










fd148775

7-8-kolpaki-koles.html

7.8. Caps of wheels

Installation of a cap of a wheel: and – the cap is centered on a spring; – the cap is established

1 – cap;

2 – clamp;

3 – spring

On the car establish plastic caps of wheels with an emblem of manufacturer. To a wheel apply a clamp and a spring to fastening of a cap.

2 caps 1 insert a clamp before installation of a wheel into its central opening.

3 fastenings of a cap insert a spring into clamp grooves so that the closed its end unbent from the general plane was turned to a wheel and rested against a clamp wall. At the same time two another bent in the general plane of the end have to leave a groove of a clamp and rest against its external wall, fixing a spring on a clamp.

ри for installation of a cap, before its zakhlopyvaniye not to damage a spring, it is necessary, having slightly pressed a cap to a spring, 2–3 times to turn it on a small corner concerning a clamp to center the directing part of a cap acting conic in relation to direct sites of a spring, and then sharp pressing to slam a cap.

If the cap is not centered, then the acting its part can rest against the direct site of a spring and at a zakhlopyvaniye to bend it. At the same time reliability of fixing of a cap considerably will worsen.



7.7. Balancing of wheels

7.9. Fastening of a spare wheel