| 1. To remove the generator, the carburetor, the ignition distributor, the thermostat, the fuel pump, an oil filter, a generator drive belt, an arm of fastening of the generator and the pump 3 (fig. Removal of the pump of cooling liquid of the engine of fashion. 2106) cooling liquid, a cover of a sapun of ventilation of a case and to take out an oil separator of ventilation of a case. |
| 2. To remove a case, the oil pump with an oil receiver, a clamp of a drain tube of an oil separator with a glass. |
| 3. To remove a pulley of a bent shaft, having fixed a flywheel 2 (fig. Removal of a flywheel of the engine of fashion. 2106) a clamp 5 and having turned off a key a ratchet. |
| 4. To uncover heads of the block of cylinders and a cover of the drive of the camshaft. |
| 5. To turn off bolts of fastening of asterisks of the camshaft and roller of the drive of the oil pump. |
| 6. To turn off the cap-type nut 1 (fig. Removal of a natyazhitel and uspokoitel of a chain of the engine mod.2106) a natyazhitel of a chain to wring out an assembly shovel a rod of a natyazhitel and to record it the cap-type nut. |
| 7. To turn off two nuts 3 fastenings of a natyazhitel of a chain to a head of the block of cylinders, to remove a natyazhitel and, having turned off a bolt 5, to take off a boot 4 natyazhitel of a chain. |
| 8. To turn away a restrictive finger of a chain, to remove asterisks of the drive of the oil pump and the camshaft and to take out a chain. |
| 9. To turn off nuts 5 (fig. Removal of a persistent flange of the camshaft of the engine mod.2106) hairpins and to remove the case of bearings of the camshaft with the camshaft. |
| 10. To turn off nuts 4 and to remove a persistent flange 1; carefully, not to damage a surface of support of the case of bearings, to take out the camshaft. |
| 11. To turn off bolts of fastening of a head of the block of cylinders and to remove it together with a final collector and the inlet pipeline. |
| 12. To remove a persistent flange 1 (fig. Removal of the roller of the drive of the oil pump of the engine mod.2106) roller. 3 drives of the oil pump and to take out the roller from the block of cylinders. |
| 13. To remove a universal stripper an asterisk from a bent shaft. |
| 14. To turn off nuts of conrod bolts, to uncover rods and to take out carefully via cylinders pistons with rods. |
Prevention
Taking out pistons, to mark the piston and a cover of its rod that at assembly to install them in former cylinders.
|
| 15. Having established a clamp 5 (see rice. Removal of a flywheel of the engine of fashion. 2106), to turn off bolts of fastening of a drive plate of coupling and to remove it together with the conducted disk. To turn off bolts 3 fastenings of a flywheel, to remove a washer 4 and a flywheel from a bent shaft. |
| 16. To remove a forward cover of the 6th case of coupling. |
|
17. A pusher to take out the bearing of a main shaft of the transmission from a nest of a bent shaft. |
| 18. To remove the holder of an epiploon of a bent shaft with an epiploon. |
| 19. To turn off bolts of covers of radical bearings, to remove them together with the lower inserts, then to remove a bent shaft, the top inserts and persistent half rings on a back support. |
