|
REASON
|
ELIMINATION METHOD
|
|
The rack (shock-absorber) is untight, a liquid leak
|
|
The shock-absorber tank nut inhaling weakened
|
To tighten a nut
|
|
The rubber cuff (epiploon) of a rod or rubber ring of the tank is damaged or worn-out
|
To replace a cuff (epiploon) or a ring of the tank
|
|
The rod is damaged or worn-out
|
To replace a rod
|
|
The rod of a rack (shock-absorber) has free (without effort) the movement at the beginning of the course of compression or a release (stretching) which is not eliminated by pumping
|
|
The amount of liquid in a rack (shock-absorber) is reduced
|
To check tightness, amount of liquid, if necessary to restore tightness and to add liquid
|
|
Operability of inlet or perepuskny valves is broken
|
To restore operability of valves – to replace the damaged details: valve, throttle disk, spring and (or) piston (compression valve case). At damage of ring locking edges but the piston or the case of the valve of compression small roughnesses can be eliminated with grinding in on a plate
|
|
The rack (shock-absorber) does not develop sufficient resistance at the release course
|
|
The release valve as a result of a contamination or damage of its details is untight
|
To disassemble the valve and to wash out, to replace the damaged details. To filter or replace liquid
|
|
The effort of a spring of the valve of a release decreased (the spring "settled")
|
To replace a spring. To increase quantity of disks of the valve of a release
|
|
Operability of the perepuskny valve is broken
|
To restore operability of the valve – to replace the damaged details: valve, throttle disk, spring, piston
|
|
The wear of details leading to the increased liquid overflowing on gaps or deep risks of the worn-out piston and its ring, the cylinder, a rod and guide
|
To replace worn-out details
|
|
The rack (shock-absorber) does not develop sufficient resistance at the compression course
|
|
Leakage of the valve of compression because of a contamination
|
To wash out the valve. To filter or replace liquid
|
|
Wear of a working surface of a rod or guide
|
To replace worn-out details
|
|
Wear, deformation or destruction (damage) of details of the valve of compression or inlet valve
|
To replace the valve of compression of a rack or a saddle
|
|
To replace details of the inlet valve of a rack
|
|
To disassemble the valve of compression of the shock-absorber and to replace the worn-out, damaged or destroyed details
|
|
The rack (shock-absorber) develops excessive resistance at the end of the compression course
|
|
Excess amount of liquid in a rack {shock-absorber)
|
To remove excess liquid
|
|
In a rack (shock-absorber) at sharp movement of a rod knocks are observed
|
|
The inhaling of a nut of the tank or fastening of the piston weakened
|
To tighten a nut of the tank or piston
|
|
In a rack (shock-absorber) jammings when moving a rod are observed
|
|
Rod bend
|
To replace a rod
|
|
Damage of the working cylinder of a rack
|
To replace the cylinder
|
|
In a rack (shock-absorber) at the end of the course of a release "failure" in work is felt (a free exit of a rod against the stop)
|
|
Insufficient amount of liquid
|
Insufficient amount of liquid
|
