|
REASON
|
ELIMINATION METHOD
|
|
The index of temperature of cooling liquid or level of fuel does not work
|
|
The index is damaged
|
To replace the index or a combination of devices
|
|
The index sensor is faulty
|
To replace the index sensor
|
|
Wires are damaged or their tips were oxidized
|
To check wires, to restore connections
|
|
The arrow of the index of level of fuel comes back to the mark "0" at a full tank
|
|
At the fuel level sensor the float course limiter is incorrectly installed: the slip ring of the sensor goes beyond a resistor winding
|
To turn in the limiter on 1–2 mm down
|
|
The arrow of the index of level of fuel moves jumps and often falls to the mark "0"
|
|
Weak contact of the resistor of the sensor with a slip ring
|
To turn in a slip ring
|
|
Break of a winding of the resistor of the sensor of the index
|
To replace the index sensor
|
|
Constantly the control lamp of a reserve of fuel burns
|
|
Short circuit of a wire of the sensor with "weight"
|
To check, eliminate short circuit
|
|
Any control lamps do not work
|
|
The lamp fused
|
To replace a lamp
|
|
The lamp sensor is faulty
|
To replace the sensor
|
|
Break in wires, oxidation of tips of wires
|
To replace the damaged wires, to smooth out tips
|
|
Insufficient clip of contacts of the boss of a lamp to the printed circuit board
|
To turn in contacts of the boss of a lamp or to replace it
|
|
The speedometer does not work
|
|
Nuts of fastening of tips of a flexible shaft of the drive of a speedometer are not tightened
|
To check, tighten nuts
|
|
Break of a flexible shaft of the drive of a speedometer
|
To replace a flexible shaft
|
|
The speedometer mechanism is damaged
|
To replace a speedometer
|
|
Noise of a flexible shaft of the drive of a speedometer
|
|
The cover of a flexible shaft of the drive (dents, excesses, etc.) is deformed
|
To replace a drive shaft
|
|
Installation of a flexible shaft is executed with radiuses of bend less than 100 mm
|
To correct installation of a flexible shaft
|
